Wall Mount Garage Door Opener Install Chamberlain Rjo70

Installing a Chamberlain RJO70 Wall Mount Garage Door Opener

Installing a garage door opener can be a daunting task, but with the right tools and instructions, it can be done relatively easily. This guide will walk you through the steps involved in installing a Chamberlain RJO70 wall mount garage door opener.

Tools and Materials Needed

Before you begin, gather the following tools and materials:

Chamberlain RJO70 wall mount garage door opener
Drill
Drill bits
Screwdriver
Wrench
Level
Pencil or marker
Safety glasses

Preparing the Installation Site

Choose a location for the wall mount opener that is within reach of a power outlet and has a clear path to the garage door. Mark the location of the mounting bracket on the wall using a pencil or marker.

Use a level to ensure that the mounting bracket is level. This is important for the proper operation of the opener.

Installing the Mounting Bracket

Drill pilot holes into the wall at the marked locations. Insert the included screws into the pilot holes and tighten them using a screwdriver or wrench.

Hang the wall mount opener on the mounting bracket. Secure it in place by tightening the included nuts using a wrench.

Connecting the Wiring

Connect the wires from the garage door opener to the corresponding terminals on the motor unit. Use the included wire nuts to secure the connections.

Connect the power cord to the power outlet.

Programming the Remote Control

The Chamberlain RJO70 wall mount garage door opener comes with two remote controls. To program the remote controls, follow these steps:

Press and hold the "Program" button on the opener unit for 5 seconds.
Press the "Open" button on the remote control.
The opener will emit a beep to indicate that the remote has been programmed.
Repeat steps 2 and 3 for each additional remote control.

Testing the Opener

Once the opener is installed and programmed, test it by pressing the "Open" button on the remote control. The garage door should open and close smoothly.

If the garage door does not open or close properly, check the following:

Make sure that the wiring is connected correctly.
Check that the remote control batteries are fresh.
Ensure that the garage door is not obstructed.
Contact Chamberlain customer support for assistance.

Conclusion

Installing a Chamberlain RJO70 wall mount garage door opener is a relatively straightforward process. By following the steps outlined in this guide, you can have your garage door opener up and running in no time.